LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2006 >> Land Cruiser >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Engine Ignition System >> VVT Sensor >> Installation
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

VVT Sensor: Installation

  1. INSTALL VVT SENSOR (for Bank 1) 
    1. Install the sensor with the bolt.

      Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

    2. Connect the connector.
  2. INSTALL VVT SENSOR (for Bank 2) 
    1. Install the sensor with the bolt.

      Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

    2. Connect the connector.
  3. INSTALL INTAKE MANIFOLD ASSEMBLY 
    1. Install the intake manifold assembly (see INSTALLATION ).
  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  5. ADD ENGINE  COOLANT 
  6. CHECK FOR ENGINE COOLANT LEAKS 
    1. Check for the engine coolant leaks (see COOLING SYSTEM ).
  7. PERFORM INITIALIZATION 
    1. Perform INITIALIZATION .
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
scientia non olet · About LEMON Manuals