Crankshaft, Engine

Crankshaft Thrust Clearance
Standard thrust clearance 0.04 to 0.24 mm (0.0016 to 0.0094 inch)
Maximum thrust clearance 0.30 mm (0.0118 inch)
If the thrust clearance is greater than maximum, measure the thrust washer thickness.
If the thickness is not as specified, replace the thrust washer.

HINT: Thrust washer thickness is 2.430 to 2.480 mm (0.0957 to 0.0976 inch).

Crankshaft
Maximum circle runout 0.03 mm (0.0012 inch)
Diameter 47.988 to 48.000 mm (1.8893 to 1.8898 inch)
Maximum taper and distortion 0.02 mm (0.0008 inch)





Diameter 43.992 to 44.000 mm (1.7320 to 1.7323 inch)
Maximum taper and distortion 0.02 mm (0.0008 inch)

Crankshaft Bearing Cap Set Bolt
Standard diameter 7.3 to 7.5 mm (0.287 to 0.295 inch)
Minimum diameter 7.3 mm (0.287 inch)