Inspection Procedure

WARNING: This page is about a different car, the 2006 Toyota Tundra and 2005 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

Check CD.
CHECK:

Check if the CD is a normal audio CD that has no cracks, scratches, deformations, dirt, or other defects.

OK:

The CD is a normal audio CD without any problems.

HINT:
- Translucent or deformed CDs cannot be played.
- CD-ROMs (even those with music) and CD-R discs cannot be played.
- A copy protected CD should not be used.
- An adaptor is not necessary to play 3.2 inch (8 cm) CDs.
1. NG : End.
2. OK : GO TO NEXT STEP
Check radio and navigation assy.
CHECK:

Check if the "DISC" indicator near the disc slot is on.

OK:

It is not on.

Fig 1: Checking Radio And Navigation Assy
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. NG : Press disc switch to eject disc.
2. OK : GO TO NEXT STEP
Check if a CD is inserted properly.
CHECK:

Check if a CD is inserted properly.

Check whether or not the CD is inserted upside down.

OK:

Not upside down.
1. NG : Set disc correctly.
2. OK : Go to next Step.
Check CD.
CHECK:

Check for dirt on the CD surface.

OK:

The CD is clean.

HINT:

If dirt is on the CD surface, wipe it with a soft cloth from inside to outside in a radial direction.

NOTE: Do not use conventional record cleaner or anti-static preservative.

Fig 2: Cleaning CD
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. NG : Clean CD.
2. OK : GO TO NEXT STEP
Check using another CD.
CHECK:

Check if the problem recurs using another CD.

OK:

The problem does not recur.
1. OK : Replace CD.
2. NG : Proceed to next circuit inspection shown in PROBLEM SYMPTOMS TABLE .