LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2004 >> Sienna CE >> Repair and Diagnosis (Single Page) >> Brakes >> Traction Control >> Steering Angle Sensor >> Replacement
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Steering Angle Sensor: Replacement

  1. PRECAUTION (See  AIR BAG SAFETY PRECAUTIONS  ) 
  2. SEPARATE BATTERY NEGATIVE TERMINAL 
  3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 
  4. REMOVE HORN BUTTON ASSY (See  DRIVER-SIDE AIR BAG MODULE  ) 
  5. REMOVE STEERING WHEEL ASSY (See  OVERHAUL  ) 
  6. REMOVE STEERING COLUMN LOWER COVER (See  OVERHAUL  ) 
  7. REMOVE SPIRAL CABLE SUB-ASSY (See  SPIRAL CABLE  ) 
  8. REMOVE STEERING SENSOR 
    1. Release the claw fittings and remove the steering sensor from the spiral cable.
    Fig 1: Removing Steering Sensor From Spiral Cable
    G03062828Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. INSTALL STEERING SENSOR 
    1. Install the steering sensor onto the spiral cable.
    Fig 2: Installing Steering Sensor From Spiral Cable
    G03062829Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 
  11. INSTALL SPIRAL CABLE SUB-ASSY (See  SPIRAL CABLE  ) 
  12. INSTALL STEERING COLUMN LOWER COVER (See  OVERHAUL  ) 
  13. CENTER SPIRAL CABLE (See  SPIRAL CABLE  ) 
  14. INSTALL STEERING WHEEL ASSY (See  OVERHAUL  ) 
  15. INSPECT STEERING WHEEL CENTER POINT 
  16. INSTALL HORN BUTTON ASSY (See  DRIVER-SIDE AIR BAG MODULE  ) 
  17. INSPECT SRS WARNING LIGHT (See  SYSTEM OPERATION CHECK  ) 
scientia non olet · About LEMON Manuals