Speed Sensor Rear LH (4WD): Replacement

WARNING: This page is about a different car, the 2004 Toyota Matrix. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE REAR WHEEL
REMOVE FUEL TANK FILLER PIPE PROTECTOR
1. Remove the 3 bolts, then remove the fuel tank filler pipe protector LH.
  
  Fig 1: Removing Fuel Tank Filler Pipe Protector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR SEAT BACK ASSY LH (See OVERHAUL )
DISCONNECT SPEED SENSOR REAR LH
1. Disconnect the speed sensor connector, and pull out the sensor wire harness with grommet.
  
  Fig 2: Disconnecting Speed Sensor Rear LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE SPEED SENSOR REAR LH
1. Remove the bolt from the body.
  
  Fig 3: Removing Bolt From Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the bolt and nut from the suspension member and upper arm.
  
  Fig 4: Removing Bolt And Nut From Suspension Member And Upper Arm
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the bolt from the knuckle, and remove the speed sensor rear LH.
NOTE: Keep on the sensor tip clean.

Fig 5: Removing Speed Sensor Rear LH
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL SPEED SENSOR REAR LH
1. Install the speed sensor rear LH with the bolt to knuckle.
  NOTE: Make sure the sensor tip is clean.
  
  Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
  
  Fig 6: Installing Speed Sensor Rear LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the clamp with the bolt and nut to the upper arm and suspension member.
  Torque: 5.0 N.m (51 kgf.cm, 44 in.lbf)
  
  Fig 7: Installing Clamp With Bolt And Nut To Upper Arm And Suspension Member
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the clamp with the bolt to the body, and install the grommet to the body.
  Torque: 5.0 N.m (51 kgf.cm, 44 in.lbf)
  
  Fig 8: Installing Clamp With Bolt To Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT SPEED SENSOR REAR LH
1. Push in the wire harness with grommet, and connect the speed sensor connector.
  
  Fig 9: Connecting Speed Sensor Rear LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR SEAT BACK ASSY LH (See OVERHAUL OVERHAUL )
INSTALL FUEL TANK FILLER PIPE PROTECTOR
1. Install the fuel tank filler pipe protector with the 3 bolts.
  
  Fig 10: Installing Fuel Tank Filler Pipe Protector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR WHEEL
Torque: 103 N.m (1,050 kgf.cm, 76 ft.lbf)
CHECK ABS SPEED SENSOR SIGNAL (See COMBINATION METER )