Draining & Refilling: Notes
WARNING: This page does not describe the selected car, but rather 29 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota RAV4, and 2002 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
A large amount of material debris including steel (magnetic) and non-magnetic (brass, aluminum or clutch fiber particles) may indicate excessive transmission wear or damage. Check the magnet in the oil pan for steel particles which indicate bearing, plate or hardware damage.
CAUTION:
When working with FIPG sealing material, you must observe the following: Using a razor blade and gasket scraper, remove all FIPG sealing material from the gasket surfaces. Thoroughly clean all components to remove all loose material. Clean both sealing surfaces with a non-residue solvent. Apply FIPG in an approximately 0.04" (1 mm) wide bead along the sealing surface. Parts must be assembled within 10 minutes of application. Otherwise, the FIPG sealing material must be removed and reapplied.
NOTE:
Always warm transmission/transaxle to operating temperature of 158-176°F (70-80°C) prior to draining and refilling.
NOTE:
When removing transmission/transaxle oil pan and filter, note bolt size and length for reassembly reference.