LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 1987 >> Van Base, Van Window, Standard >> Repair and Diagnosis >> Body & Frame >> Power Windows >> Removal & Installation >> Service Hole Cover >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Service Hole Cover: Installation

  1. Connect the wire harness connector.
  2. Seal the service hole cover with adhesive.
  3. Insert the lower edge of the service hole cover into the panel slit. See Fig 1.
    4. NOTE: Do not block the trim clip seating with the tape.
  4. Seal the panel slit with cotton tape. See Fig 2.
Fig 1: Installing Service Hole Cover
G00118023Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 2: Sealing Service Hole Cover
G00118024Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals