LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 1986 >> Van LE >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Cruise Control Systems >> Cruise Control System - Non-Diagnostic >> Circuit Testing >> Control Switch Circuit
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Control Switch Circuit

  1. Turn ignition off. Check for continuity between terminal No. 28 of control switch (terminal No. 1 on Van) and good body ground with "ACCEL/RESUME" in "ON" position. If continuity is not present, test control switch.
  2. If continuity is present, repeat step 1) with "ACCEL/RESUME" in "OFF" position. If continuity is present, test control switch. If continuity is not present, disconnect wiring harness connector at cruise control computer.
  3. Check for continuity between harness terminal No. 13 of computer (terminal No. 16 on Van) and good body ground with "ACCEL/RESUME" in "ON" position. If continuity is not present, check for open in harness between terminal No. 13 of computer (terminal No. 16 on Van) and terminal No. 28 of control switch (terminal No. 1 on Van).
  4. If continuity is present, check operation of actuator. Replace actuator if not operating properly. If actuator is operating properly, replace cruise control computer.
scientia non olet · About LEMON Manuals