September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Throttle Position Sensor (TPS) Adjustment
- Loosen 2 TPS retaining screws. Insert a thickness gauge between throttle stop screw and throttle. With ignition off and electrical connector disconnected, connect ohmmeter between terminals IDL and E2.
THROTTLE POSITION SENSOR ADJUSTMENT
| Model |
Gap In. (mm) |
| Cressida & Supra |
.020 (.50) |
- Gradually turn TPS counterclockwise until ohmmeter needle deflects. Secure TPS retaining screws. Using a thickness gauge, recheck the continuity between terminals IDL - E2.