Wheel - Remove And Install: Install

Install wheel onto the hub.
Hand start the lug nuts (x5) beginning with the bottom lug nut first.
Use a power tool to tighten the lug nuts (x5) of the wheel to the initial torque in a criss-cross star pattern.

Courtesy of TESLA, INC.
Lower the vehicle until the tire is touching the floor and the suspension begins to load.
Torque the lug nuts (x5) of the wheel in a criss-cross star pattern.
175 N.m (129.1 ft-lbs)

CAUTION: If using a floor jack, make sure not to rock the vehicle off of the jack.

Courtesy of TESLA, INC.
Install the lug nut covers (x5) onto the wheel.

Courtesy of TESLA, INC.
Fully lower the vehicle completely.
On the vehicle touchscreen, touch Controls > Service > Suspension > Disable Jack Mode to disable Jack Mode.
Remove the vehicle from the 2 post lift. See Raise Vehicle - 2 Post Lift .
NOTE: If using a floor jack, remove the floor jack out from under the vehicle.