September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Light - Map - Front - Remove and Replace: Installation
- If previously removed, install the intrusion sensors (x2) into the map light, and then fasten the clips that attach each sensor to the map light.
 Courtesy of TESLA, INC.
|
- Pass the map light connector through the headliner, install the map light into the headliner, and then fasten the clips (x4) that attach the map light to the headliner.
NOTE:
If installed, make sure that the intrusion sensor connectors pass through the headliner.
 Courtesy of TESLA, INC.
|
- If installed, connect the intrusion sensor electrical harness connectors (x2) to the intrusion sensor module.
 Courtesy of TESLA, INC.
|
- Connect the headliner electrical harness to the map light connector.
 Courtesy of TESLA, INC.
|
- Install the headliner. See HEADLINER (REMOVE AND REPLACE)
.