Fuse Box - Cabin - Front - Remove And Replace: Removal
- Open the hood.
- Open the RH front door and lower the RH front window.
- Move the front passenger seat fully rearwards.
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace) .
- Remove the LH and RH underhood aprons. See Underhood Apron - LH (Remove and Replace) .
- Remove the inlet HEPA filter duct. See Duct - HEPA Filter - Inlet (Remove and Replace) .
- Remove the outlet HEPA filter duct. See Duct - HEPA Filter - Outlet (Remove and Replace) .
- Disconnect 12V power. See DISCONNECT 12V POWER .
- Remove the RH floor mat.
- Remove the RH center console closeout extension. See Assembly - Closeout Extension - LH - Center Console (Remove and Replace) .
- Remove the RH instrument panel side cover. See Assembly - Instrument Panel Side Cover - LH (Remove and Replace) .
- Remove the RH middle A-pillar trim. See Panel - A Pillar Trim - Middle - LH (Remove and Replace) .
- Remove the RH sill panel trim. See Trim - Sill Panel - LH (Remove and Replace) .
- Remove the RH footwell cover. See Assembly - Cover - Footwell - Passenger's (Remove and Replace) .
- Fold the front portion of RH front carpet down.
- Disconnect the electrical connectors (x7) on the outer side from the WIP harness bracket, and then slide it from the fuse box bracket.
- Disconnect the electrical connectors (x10) to the fuse box.
- Remove and discard the nut that attaches the 12V input harness.
Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- Press the clips (x2 bottom, x2 top) on the bottom to release fuse box, and then remove the fuse box from the vehicle.