Keyless Entry Receiver and Its Circuit Inspection (If Equipped)

1. Check that the voltage between the following terminals and body ground are specifications under each conditions. If check result is not as specified, check applicable circuit for open or short. If circuit is normal, proceed to next step.
   Fig 1: Inspecting Keyless Entry Receiver

   Courtesy of SUZUKI OF AMERICA CORP.
   KEYLESS ENTRY RECEIVER SYMPTOM DIAGNOSIS CHART
   
   

   Terminal	Circuit	Specification	Condition
   1	Power source	Fig 1	Push "Lock" or "Unlock" button on transmitter.
   		0 - 1 V	Except the above-mentioned condition.
   3	Lock/Unlock output signal circuit	Fig 1	Push "Lock" or "Unlock" button on transmitter.
   		0 - 1 V	Except the above-mentioned condition.
   4	Ground	0 - 1 V	-

Oscilloscope setting 

CH1: 2V/DIV

CH2: 2V/DIV

TIME: 200 ms/DIV

Fig 2: Oscilloscope Waveform Graph

Courtesy of SUZUKI OF AMERICA CORP.

1. Recheck keyless entry receiver as follows.
   1. Substitute a known-good keyless entry receiver.
   2. Record key code referring to PROGRAMMING TRANSMITTER CODE FOR KEYLESS ENTRY SYSTEM (OTHER THAN KEYLESS START MODEL) .
   3. Recheck keyless entry receiver system.