DTC Check

WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch to OFF position.
Connect SUZUKI scan tool to DLC (1).
Special Tool

(A): SUZUKI scan tool (SUZUKI-SDT)

Fig 1: Connecting Suzuki Scan Tool To DLC
Courtesy of SUZUKI OF AMERICA CORP.
Turn ignition switch to ON position.
Read DTC according to instructions displayed on SUZUKI scan tool and print it or write it down. Refer to SUZUKI scan tool operators manual for further details.
NOTE: If SUZUKI scan tool can not communicate ESP® control module, perform SERIAL DATA LINK CIRCUIT CHECK .
After completing the check, turn ignition switch off and disconnect SUZUKI scan tool from DLC.