LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Standard Trans >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Air Conditioning System >> Diagnostic Information and Procedures >> DTC Clearance >> Using SUZUKI Scan Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Using SUZUKI Scan Tool

  1. Confirm that ignition mode of keyless push start system is "OFF".
  2. Connect SUZUKI scan tool to DLC (1).

    Special Tool 

    1. SUZUKI scan tool (SUZUKI-SDT) 
    Fig 1: Connecting SUZUKI Scan Tool To DLC
    G06526689Courtesy of SUZUKI OF AMERICA CORP.
  3. Push engine switch to change ignition mode to "ON".
  4. Erase DTC according to instructions displayed on SUZUKI scan tool. Refer to SUZUKI scan tool operator's manual for further details.
  5. Perform DTC CHECK  and confirm if normal DTC (NO CODES) is displayed.
  6. After completing clearance, push engine switch to change ignition mode to "OFF" and disconnect SUZUKI scan tool from DLC.
scientia non olet · About LEMON Manuals