LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Standard Trans >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Air Conditioning System >> Diagnostic Information and Procedures >> DTC Check >> Not Using SUZUKI Scan Tool >> History DTC
April 5, 2026: LEMON Manuals is launched! Read the announcement.

History DTC

  1. Push engine switch to change ignition mode to "ON".
  2. Set driver and passenger side temperature selector to 72 °F or 25 °C.
  3. Push "AUTO" switch (1) and "MODE" switch (2) simultaneously.
    NOTE: Steps  2) and  3) must be finished within 15 seconds after completing Step  1).
  4. Check for DTC (3), see DTC TABLE .
    NOTE:
    • If history DTC is stored in HVAC control module, fan mark (4) and history DTC is displayed on VFD for about 3 minutes continuously.
      Fig 1: Identifying Auto Switch And Mode Switch
      G06526688Courtesy of SUZUKI OF AMERICA CORP.
    • If no history DTC is stored in its memory, fan mark and "END" is displayed on VFD for about 3 minutes continuously.
    • When HVAC control module stores 2 or more history DTCs, each one is displayed once starting from the higher priority DTC.
    • History DTC is displayed on VFD according to the following steps:
      1. Higher priority DTC appears for 4 seconds.
      2. No DTC appears for 0.5 second.
      3. Next priority DTC appears for 4 seconds.
      4. No DTC appears for 0.5 second.
      5. Remaining DTCs are displayed in order of priority.
      6. DTC display is repeated in same step for about 3 minutes.
    • HVAC control module will cancel DTC display due to any of the following conditions:
      • Ignition mode of keyless push start system is changed to "OFF".
      • Both "AUTO" switch and "MODE" switch are pushed simultaneously.
  5. After completing above check, push engine switch to change ignition mode to "OFF".
scientia non olet · About LEMON Manuals