LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Standard Trans >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> Without SUZUKI Scan Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Without SUZUKI Scan Tool

  1. Ensure all 4 doors are closed and ignition mode of keyless push start system is "OFF".
  2. Open the driver's door. Perform the following within 15 seconds after ignition switch is turned to ON position:
    • Press driver-side door switch within 5 seconds. Keep switch pressed for 2 seconds.
    • Release driver-side door switch, then press it again for 2 seconds or more.
    • Release driver-side door switch, then press it again for 2-5 seconds.
  3. Using TPM Activation Tool (09945-86510), activate each tire pressure sensor, according to the instructions displayed on activation tool, within 90 seconds.
    NOTE: Ensure activation tool is positioned as shown in Figure, or sensor IDs may not register.
    NOTE: If ID code registration of all 4 tire pressure sensors does not occur within 90 seconds, repeat procedure.
  4. As each tire pressure sensor is activated, the activation tool will flash its LED and beep. If the activation tool is working properly but does not flash and beep, replace faulty tire pressure sensor.
  5. To verify the IDs are being registered, observe the flash patterns of the dashboard low tire pressure warning light. See Tire Pressure Sensor Activation Specifications  table.
  6. When tire pressure sensor is activated, ID code of tire pressure sensor is registered automatically in keyless start control module. If each of the ID codes of all tire pressure sensors is not registered in the keyless start control module within 180 seconds, repeat procedure from beginning.
  7. Push engine switch to change ignition mode to "OFF" after registration is completed.
scientia non olet · About LEMON Manuals