Transfer Dismounting and Remounting: Dismounting

WARNING: This page is about a different variant/trim than selected.

Remove right and left side engine under covers.
Remove exhaust pipe No. 1 and No. 2, see EXHAUST PIPE AND MUFFLER REMOVAL AND INSTALLATION .
Remove propeller shaft, see PROPELLER SHAFT ASSEMBLY REMOVAL AND INSTALLATION .
Drain following oil and fluid.
- Transfer oil: TRANSFER OIL CHANGE
- CVT fluid: CVT FLUID CHANGE
Remove right side drive shaft assembly, see FRONT DRIVE SHAFT ASSEMBLY REMOVAL AND INSTALLATION .
Disconnect transfer oil temperature sensor connector (1), and remove harness (2) from transfer (3).

Fig 1: Identifying Transfer Oil Temperature Sensor Connector And Harness
Courtesy of SUZUKI OF AMERICA CORP.
Remove transfer stiffener bolts (1) and transfer stiffener (2).

Fig 2: Identifying Transfer Stiffener Bolts And Transfer Stiffener
Courtesy of SUZUKI OF AMERICA CORP.
Remove engine rear mounting bracket No. 1 bolts (1).

Fig 3: Identifying Engine Rear Mounting Bracket No. 1 Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Remove transfer bolts (1) and nut (2) and transfer (3) from CVT assembly.
CAUTION: Be careful not to damage CVT case while removing the transfer.

Fig 4: Identifying Transfer Bolts And Nut
Courtesy of SUZUKI OF AMERICA CORP.