Centering of Contact Coil Cable Assembly

WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.

Reference: CONTACT COIL CABLE ASSEMBLY REMOVAL AND INSTALLATION

Remove steering wheel, see Steering Wheel Removal and Installation .
Confirm that ignition mode of keyless push start system is in "OFF".
Turn contact coil cable assembly fully counterclockwise.
CAUTION: Turning with excessive force will break coil. Turn rotation part (2) with a light force holding bottom of connector (1).

Fig 1: Turning Contact Coil Cable Assembly
Courtesy of SUZUKI OF AMERICA CORP.
From the position of Step 3), turn it back clockwise and position connector at top within one rotation.
Turn rotation part (2) two turns clockwise and position connector (1) at top. Check that triangle mark (4) on rotation part (2) is aligned with that on fixed part (3) and orange roller (5) is visible in hole as shown in figure.

Fig 2: Identifying Triangle Mark On Rotation Part And Orange Roller
Courtesy of SUZUKI OF AMERICA CORP.