DTC Confirmation Procedure
WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Perform ROAD TEST in a place where there is no traffic to prevent an accident.
- Road test should be performed by two persons, a driver and a tester, on a level road.
NOTE:
- Be sure to troubleshoot first unexpected DTCs previously detected in "DTC Confirmation Procedure".
- Confirm that the following conditions are met in this procedure.
- Battery voltage > 10.5 V
- 0.5 < Gear ratio < 1.0
- Drive vehicle at 30 - 50 km/h (19 mile/h - 31 mile/h) constantly for 40 sec. or more at "D" range. (Keep throttle valve opening constantly in this step).
- Stop vehicle.
- Push engine switch to change ignition mode to "OFF" and leave ignition mode in "OFF" for 10 sec.
- Push engine switch to change ignition mode to "ON".
- Repeat Step 1) through 2) twice.