LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Differential) >> Diagnostic Information and Procedures >> DTC C1282: 4WD Abnormal Heat Generation >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
DTC TROUBLESHOOTING CHART

Step Action YES NO
1  Check TDC 
  1. Clear DTC.
  2. Perform DTC CONFIRMATION PROCEDURE , and CHECK DTC .

Is DTC C1282 still detected? 		 Go to Step 2. End.
2  Parameter check 1 
  1. Connect SUZUKI scan tool to DLC with ignition mode of keyless push start system in "OFF".
  2. Push engine switch to change ignition mode to "ON".
  3. Check "Transfer Oil Temperature" displayed on SUZUKI scan tool.

Is maximum value or current value higher than 120°C (248°F)? 		 Keep ignition mode of keyless push start system in "ON" until parameter reading of "Transfer Oil Temperature" falls below 120°C (248°F). Go to Step 3. Go to Step 3.
3  Parameter check 2 
  1. Check "4WD Unit Temperature" displayed on SUZUKI scan tool.

Is maximum value or current value higher than 80°C (176°F)? 		 Keep ignition mode of keyless push start system in "ON" until parameter reading of "4WD Unit Temperature" falls below 80°C (176°F). Go to Step 4. Go to Step 4.
4  Check TDC 
  1. Clear DTC.
  2. Perform DTC CONFIRMATION PROCEDURE , and CHECK DTC .

Is DTC C1282 still detected? 		 Keep ignition mode of keyless push start system in "ON" for 30 minutes. End.
scientia non olet · About LEMON Manuals