Curtain Air Bag (Inflator) Module Removal and Installation: Installation

WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.

Reverse removal procedure noting the following points.

Install curtain air bag (inflator) module without twisting marking line (1) on strap part and part number marking character (2).

Fig 1: Identifying Marking Line On Strap Part And Character On Curtain Air Bag (Inflator) Module
Install claw (1) of curtain air bag (inflator) module to vehicle hole (2).

Fig 2: Identifying Curtain Air Bag (Inflator) Module Claw
Use new curtain air bag (inflator) module bolt as it is pre-coated bolt and tighten to specified torque.
Tightening torque

Curtain air bag (inflator) module bolts (a): 11 N.m (1.1 kg-m, 8.0 lbf-ft)

NOTE: Check that bracket of clamping part to body is securely fixed after tightening curtain air bag (inflator) module bolt.
Enable air bag system.