LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine General Information & Diagnosis >> Diagnostic Information and Procedures >> Engine Basic Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Basic Inspection

Perform troubleshooting referring to the following points when no DTC is detected in ECM and no abnormality is found in VISUAL INSPECTION .

DIAGNOSTIC PROCEDURES CHART

Step Action YES NO
1  Was "Engine and Emission Control System Check" performed?  Go to Step 2. Go to ENGINE AND EMISSION CONTROL SYSTEM CHECK .
2  Check battery voltage 
Is it 11 V or more? 		 Go to Step 3. Charge or replace battery.
3  Can engine be cranked?  Go to Step 4. Go to CRANKING SYSTEM SYMPTOM DIAGNOSIS .
4  Does engine start?  Go to Step 5. Go to Step 7.
5  Check idle speed 
  1. Check engine idle speed, see IDLE SPEED INSPECTION .

Is check result as specified? 		 Go to Step 6. Go to ENGINE SYMPTOM DIAGNOSIS .
6  Check ignition system 
  1. Check ignition system. Refer to IGNITION SYSTEM CHECK

Is check result as specified? 		 Go to ENGINE SYMPTOM DIAGNOSIS . Repair or replace defective parts.
7  Check immobilizer system for operation 
  1. Check immobilizer control system, see IMMOBILIZER CONTROL SYSTEM CHECK .

Is it in good condition? 		 Go to Step 8. Immobilizer control system malfunction.
8  Check fuel system 
  1. Check fuel system, see FUEL SYSTEM INSPECTION .

Is it in good condition? 		 Go to ENGINE SYMPTOM DIAGNOSIS . Repair or replace defective parts.
scientia non olet · About LEMON Manuals