LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine General Information & Diagnosis >> Diagnostic Information and Procedures >> DTC Clearance >> Pending and Confirmed DTC
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pending and Confirmed DTC

  1. With ignition mode of keyless push start system in "OFF", connect CAN communication OBD-II generic scan tool or SUZUKI scan tool to DLC.
  2. Push engine switch to change the ignition mode to "ON".
  3. Erase DTC according to instructions displayed on scan tool. Freeze frame data is cleared with the DTC. Refer to scan tool operator's manual for details.
  4. After completing the clearance, push engine switch to change the ignition mode to "OFF" and disconnect scan tool from DLC.
    NOTE: Pending and confirmed DTC and freeze frame data stored in ECM memory are also cleared in the following cases. Be careful not to clear them before saving their records.
    • When power to ECM is cut off (by disconnecting battery cable, removing fuse or disconnecting ECM (connectors)).
    • When the same malfunction (DTC) is not detected again during 40 engine warm-up cycles, refer to Warm-Up Cycle of OBD SYSTEM DESCRIPTION  .
    • Even though the pending and confirmed DTCs are cleared, the permanent DTC will not be cleared.
scientia non olet · About LEMON Manuals