LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Automatic CVT Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Continuously Variable Transaxle (CVT) >> Diagnostic Information and Procedures >> DTC P1818: Stepper Motor Performance >> DTC Confirmation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Confirmation Procedure

WARNING: If you do not select a suitable route and take proper precautions when performing a road test, an accident can occur.
  • Select a level road with no traffic to minimize the risk of accident.
  • Perform the test extremely carefully.
  • Perform the road test using 2 persons, a driver and an assistant.
NOTE:
  • If other DTC than P1818 is newly detected during this "DTC Confirmation Procedure", troubleshoot the newly detected DTC in first.
  • Confirm that the following conditions are met in this procedure.
    • Battery voltage > 10.5 V
  1. Drive vehicle at more than 50 km/h (31 mile/h) for 10 sec.
  2. Stop vehicle.
  3. Push engine switch to change ignition mode to "OFF", and leave ignition mode in "OFF" for 10 sec.
  4. Push engine switch to change ignition mode to "ON".
  5. Repeat Step  1) through  2) twice.
scientia non olet · About LEMON Manuals