LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Automatic CVT Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Continuously Variable Transaxle (CVT) >> Diagnostic Information and Procedures >> DTC Clearance >> Pending and Confirmed DTC
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pending and Confirmed DTC

  1. Confirm that ignition mode of keyless push start system is in "OFF".
  2. Connect CAN communication OBD generic scan tool or SUZUKI scan tool to DLC. See DTC CHECK .
  3. Push engine switch to change ignition mode to "ON".
  4. Erase DTC and pending DTC according to instructions displayed on scan tool. Refer to scan tool operator's manual for further details.

    If communication between scan tool and TCM is not possible, go to CAN COMMUNICATION CHECK .

  5. After completing clearance, push engine switch to change ignition mode to "OFF" and disconnect scan tool from DLC.
    NOTE: Pending and confirmed DTC and freeze frame data stored in TCM memory are also cleared in the following cases. Be careful not to clear them before recording them.
    • When the same malfunction (DTC) is not detected again during 40 engine warm-up cycles.
    • Even though the pending and confirmed DTCs are cleared, the permanent DTC will not be cleared.
scientia non olet · About LEMON Manuals