Control Rod/Bushing Disassembly and Reassembly: Reassembly

Reverse disassembly procedure, noting the following points.

• Use special tool and hydraulic press (1) to press fit control rod bushing (2).
• Bushing should be directed as shown below and both ends of bushing collar (4) projecting from control rod should be the same in amount.
  CAUTION: Any removed bushing will not fit properly if you reuse it. Always use a new bushing.

  Special Tool 

  1. 09913-85210 

Fig 1: Identifying Hydraulic Press And Control Rod Bushing

Courtesy of SUZUKI OF AMERICA CORP.

Fig 2: Identifying Control Rod Bushing

Courtesy of SUZUKI OF AMERICA CORP.

Fig 3: Identifying Collar And Control Rod Bushing

Courtesy of SUZUKI OF AMERICA CORP.