P/S Motor Inspection

Confirm that ignition mode of keyless push start system is in "OFF".
Disconnect "P/S control module (P/S motor (1P))" connector and "P/S control module (P/S motor (2P))" connector from P/S control module.
Check continuity between each terminal at P/S motor side. Replace steering gear case if defective.
P/S motor circuit resistance

Between "A-1" terminal and "B-1" terminal Continuity (at 20 °C (68 °F))

Between "A-1" terminal and "B-2" terminal Continuity (at 20 °C (68 °F))

Between "B-1" terminal and "B-2" terminal Continuity (at 20 °C (68 °F))

Fig 1: Identifying P/S Motor Connector Terminals
Courtesy of SUZUKI OF AMERICA CORP.