LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Automatic CVT Trans >> Repair and Diagnosis >> General Information >> OEM General Information >> Precautions >> Repair Instructions >> Electrical Circuit Inspection Procedure >> Short Circuit Check (Wire Harness to Ground)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Short Circuit Check (Wire Harness to Ground)

  1. Disconnect negative (-) cable at battery.
  2. Disconnect connectors at both ends of the circuit to be checked.
    NOTE: If the circuit to be checked is connected to other parts (1), disconnect all connections to these parts.
    This is essential to having correct check results.
  3. Measure resistance between the terminal at one end of the circuit ("A-1" terminal in the figure) and ground. If continuity is indicated, it means that the circuit is shorted to ground between terminals "A-1" and "C-1".
    Fig 1: Measuring Resistance Between Terminal And Ground
    G06528005Courtesy of SUZUKI OF AMERICA CORP.
  4. Disconnect the connector included in circuit (connector-B) and measure resistance between "A-1" and ground. If continuity is indicated, the circuit is shorted to ground between terminals "A-1" and "B-1".
    Fig 2: Measuring Resistance Between "A-1" And Ground
    G06528006Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals