Manual Transaxle Unit Dismounting and Remounting: Remounting
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- Be careful not to damage differential side oil seal while reinstalling transaxle and drive shafts.
- Do not hit drive shaft joint with hammer when installing it into differential gear.
Reverse dismounting procedure noting the following points:
- Tighten each bolt and nut to specified torque.
- Manual transaxle: MANUAL TRANSAXLE UNIT COMPONENTS
- Front drive shaft/Drive intermediate shaft: FRONT DRIVE SHAFT COMPONENTS
- Starting motor: STARTING MOTOR REMOVAL AND INSTALLATION
- Front suspension frame: FRONT SUSPENSION FRAME COMPONENTS
- Clutch housing lower plate: OIL PAN AND OIL PUMP STRAINER REMOVAL AND INSTALLATION
- Engine left mounting bracket: ENGINE MOUNTINGS COMPONENTS
- Engine left mounting: ENGINE MOUNTINGS COMPONENTS
- Engine front mounting bracket: ENGINE MOUNTINGS COMPONENTS
- Engine front mounting: ENGINE MOUNTINGS COMPONENTS
- Engine rear mounting bracket No. 1: ENGINE MOUNTINGS COMPONENTS
- Engine rear mounting bracket No. 2: ENGINE MOUNTINGS COMPONENTS
- Engine rear mounting: ENGINE MOUNTINGS COMPONENTS
- Set each clamp for wiring securely.
- Fill with transaxle oil. See MANUAL TRANSAXLE OIL CHANGE
- Connect battery and check function of engine, clutch and transaxle.