Seat Position Memory Initialization (If Equipped)

WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Initialization is not completed if power supply of power seat control module is interrupted during initialization.
Repeat the same procedure from the beginning if power is interrupted during initialization.
Buzzer sounds twice when initialization of all motors is completed.

Operate each motor, one at a time, to move seat to position indicated in the following table and hold seat at each position for at least 5 seconds.

MOTOR POSITION CHART

Motor	Position
Slide motor	Rear end
Reclining motor	Front end
Lifter motor	Bottom end
Tilt motor	Bottom end