P/S Motor Inspection
WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
- Confirm that ignition mode of keyless push start system is in "OFF".
- Disconnect "P/S control module (P/S motor (1P))" connector and "P/S control module (P/S motor (2P))" connector from P/S control module.
- Check continuity between each terminal at P/S motor side. Replace steering gear case if defective.
P/S motor circuit resistance
Between "A-1" terminal and "B-1" terminal Continuity (at 20 °C (68 °F))
Between "A-1" terminal and "B-2" terminal Continuity (at 20 °C (68 °F))
Between "B-1" terminal and "B-2" terminal Continuity (at 20 °C (68 °F))