LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Continuously Variable Transaxle (CVT)) >> Diagnostic Information and Procedures >> DTC P0961: Pressure Control Solenoid "A" Control Circuit Range/Performance >> DTC Confirmation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Perform ROAD TEST  in a place where there is no traffic to prevent an accident.
  • Road test should be performed by two persons, a driver and a tester, on a level road.
NOTE:
  • Be sure to troubleshoot first unexpected DTCs previously detected in "DTC Confirmation Procedure".
  • Confirm that the following conditions are met in this procedure.
    • Battery voltage > 10.5 V
  1. Drive vehicle at more than 10 km/h (6 mile/h) for 5 sec.
  2. Stop vehicle.
  3. Push engine switch to change ignition mode to "OFF", and leave ignition mode in "OFF" for 10 sec.
  4. Push engine switch to change ignition mode to "ON".
  5. Repeat Step  1) through  2) twice.
scientia non olet · About LEMON Manuals