LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Differential) >> Diagnostic Information and Procedures >> DTC C1240: 4WD Control Module Power Supply Circuit Malfunction >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
DTC TROUBLESHOOTING CHART

Step Action YES NO
1  Was "4WD control system check" performed?  Go to Step 2. Go to 4WD CONTROL SYSTEM CHECK .
2  4WD control module power supply circuit check 
  1. Disconnect "L14" connector with ignition mode of keyless push start system in "OFF".
  2. Check for proper terminal connection to "L14" connector.
  3. If connection is OK, check that voltage between "A1" circuit and ground is battery voltage.

Is it in good condition? 		 Go to Step 3. "4WD" fuse blown, repair or replace defective wire harness.
3  4WD control module ground circuit check 
  1. Check that resistance between "A2" circuit and ground is less than 1 Ω.

Is it in good condition? 		 Go to Step 4. Repair or replace defective wire harness.
4  Charging system check 
  1. Check charging system, see GENERATOR TEST .

Is it in good condition? 		 Substitute a known-good 4WD control module and recheck DTC, see 4WD Control Module Removal and Installation . Repair or replace charging system.
scientia non olet · About LEMON Manuals