Not using SUZUKI scan tool
WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
- Confirm that all doors are closed and ignition mode of keyless push start system is "OFF".
- Open driver side door.
- Perform the following Steps a) to c) within 15 seconds after ignition mode in "ON".
- Press driver side door switch by hand within 5 seconds after ignition mode in "ON". Keep pressing driver side door switch for 2 seconds.
- Release driver side door switch and then press driver side door switch for 2 seconds or more by hand.
- Release driver side door switch and then press driver side door switch for 2 - 5 seconds by hand.
- Using recommended tool ("VT55" made by ATEQ) (1), activate each tire pressure sensor within 180 seconds.
Refer to instruction of recommended tool for method of activating tire pressure sensor.
NOTE:- When tire pressure sensor is activated, ID code of tire pressure sensor is registered automatically in keyless start control module.
- If all 4 tire pressure sensor ID codes are not registered in keyless start control module within 180 seconds, perform the above steps again. Also, it is possible to check the number of tire pressure sensor ID codes received by keyless start control module by observing the flashing pattern of low tire pressure warning light.
- If registration of tire pressure sensor ID codes are not completed within 180 seconds, former ID codes remain in keyless start control module.
- When keyless start control module receives all 4 tire pressure sensor ID codes, keyless start control module turns ON low tire pressure warning light in combination meter for 5 seconds.
- Push engine switch to change ignition mode to "OFF" after registration is completed.