LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Body Electrical Control System) >> Diagnostic Information and Procedures >> DTC B1690: Steering Angle Sensor Malfunction >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSIS PROCEDURE

Step Action YES NO
1  DTC check 
  1. Check DTC in ESP® control module, see DTC Table .

Is there any DTC(s) detected? 		 Go to troubleshooting for applicable DTC. Go to Step 2.
2  Steering angle sensor calibration 
  1. Perform steering angle sensor calibration, SENSOR CALIBRATION OF ESP(R) .
  2. Check DTC in BCM.

Is DTC B1690 still detected? 		 Go to Step 3. End. (Incomplete calibration of steering angle sensor)
3  DTC recheck 
  1. Replace steering angle sensor, see STEERING ANGLE SENSOR REMOVAL AND INSTALLATION .
  2. Check DTC in BCM.

Is DTC B1690 still detected? 		 Substitute a known-good BCM and recheck DTC. End. (Steering angle sensor was faulty)
scientia non olet · About LEMON Manuals