LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Body Electrical Control System) >> Diagnostic Information and Procedures >> DTC B1683: Yaw Rate Information Mismatched >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSIS PROCEDURE

Step Action YES NO
1  DTC check 
Is there any DTC(s) other than B1683? 		 Go to troubleshooting for applicable DTC. Go to Step 2.
2  DTC check 
  1. Check DTC in ESP® control module, see DTC Table .

Is there any DTC(s) detected? 		 Go to troubleshooting for applicable DTC. Go to Step 3.
3  DTC recheck 
  1. Replace steering angle sensor, see STEERING ANGLE SENSOR REMOVAL AND INSTALLATION
  2. Perform DTC CONFIRMATION PROCEDURE  and then recheck DTC.

Is DTC B1683 still detected? 		 Go to Step 4. End. (Steering angle sensor was faulty)
4  DTC recheck 
  1. Replace ESP® control module, see ESP(R) HYDRAULIC UNIT/CONTROL MODULE ASSEMBLY REMOVAL AND INSTALLATION .
  2. Perform DTC CONFIRMATION PROCEDURE  and then recheck DTC.

Is DTC B1683 still detected? 		 Substitute a known-good BCM and recheck DTC. End. (ESP® control module was faulty)
scientia non olet · About LEMON Manuals