LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Communication System) >> Diagnostic Information and Procedures >> Troubleshooting for Communication Bus Off >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.

When "CAN Communication Bus Off" is detected in any control modules, or when it is not possible to communicate with all control modules/sensors with CAN by using SUZUKI scan tool, check the following procedure.

  1. Connect oscilloscope or SUZUKI scan tool to DLC with ignition mode in "OFF".
  2. Using oscilloscope or oscilloscope function of SUZUKI scan tool, observe waveform in the following condition when ignition mode is "ON".
    TERMINAL CHANNEL REFERENCE CHART

    Channel Probe Terminal No.
    1 + G211-6, see CAN Communication System Circuit Diagram .
    - Ground
    2 + G211-14, see CAN Communication System Circuit Diagram .
    - Ground
  3. Compare observed signal waveform and waveforms given as "Reference Waveform:". Find the most similar signal waveform and identify the trouble system and trouble cause.
  4. Perform TROUBLESHOOTING .
scientia non olet · About LEMON Manuals