Engine Basic Inspection

WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.

Perform troubleshooting referring to the following points when no DTC is detected in ECM and no abnormality is found in VISUAL INSPECTION .

DIAGNOSTIC PROCEDURES CHART

Step	Action	YES	NO
1	Was "Engine and Emission Control System Check" performed?	Go to Step 2.	Go to ENGINE AND EMISSION CONTROL SYSTEM CHECK .
2	Check battery voltage Is it 11 V or more?	Go to Step 3.	Charge or replace battery.
3	Can engine be cranked?	Go to Step 4.	Go to CRANKING SYSTEM SYMPTOM DIAGNOSIS .
4	Does engine start?	Go to Step 5.	Go to Step 7.
5	Check idle speed Check engine idle speed, see Idle Speed Inspection . Is check result as specified?	Go to Step 6.	Go to ENGINE SYMPTOM DIAGNOSIS .
6	Check ignition system Check ignition system. Is check result as specified?	Go to ENGINE SYMPTOM DIAGNOSIS .	Repair or replace defective parts.
7	Check immobilizer system for operation Check immobilizer control system, see IMMOBILIZER CONTROL SYSTEM CHECK . Is it in good condition?	Go to Step 8.	Immobilizer control system malfunction.
8	Check fuel system Check fuel system, see FUEL SYSTEM INSPECTION . Is it in good condition?	Go to ENGINE SYMPTOM DIAGNOSIS .	Repair or replace defective parts.