Tightening Torque Specifications
WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
For fastener with * (asterisk) below, be sure to tighten it according to specified procedure in "Repair Instructions".
TORQUE SPECIFICATION
| Fastening part | Tightening torque | ||
|---|---|---|---|
| N.m | kgf-m | lbf-ft | |
| Drive shaft nut* | 250 | 25.5 | 184.5 |
| Intermediate support bolt* | 55 | 5.6 | 40.5 |
| Front wheel hub assembly bolt | 70 | 7.1 | 52.0 |
NOTE:
The specified tightening torque is described in the following.
FRONT DRIVE SHAFT COMPONENTS: FRONT
FRONT WHEEL HUB AND STEERING KNUCKLE COMPONENTS: FRONT
FRONT DRIVE SHAFT COMPONENTS: FRONT
FRONT WHEEL HUB AND STEERING KNUCKLE COMPONENTS: FRONT
Reference:
For the tightening torque of fastener not specified in this section, refer to FASTENERS INFORMATION .