Disabling Procedure (Removing "A/B" Fuse)

WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: In disabling procedure with "A/B" fuse removed, be sure to observe the followings.

As negative (-) cable of battery is not disconnected, air bag (inflator) module or seat belt pretensioner may be deployed accidentally if drive circuit (+) causes a power short and drive circuit (-) a ground short respectively.
In case damage to vehicle wiring harness is found in prior visual check, carry out disabling procedure with negative (-) cable disconnected from battery.

NOTE: Air bag warning light will light if "A/B" fuse is disconnected, but this is normal and DTC for air bag system will not be detected.

Push engine switch to change ignition mode to "OFF".
Remove "A/B" fuse from junction block.
Wait for at least 90 seconds after performing Step 2).
Start working and change ignition mode to ON.