LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Electronic Stability Program) >> Diagnostics Information and Procedures >> DTC Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Check

WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
  1. Confirm that ignition mode of keyless push start system is in "OFF".
  2. Connect SUZUKI scan tool to DLC (1).

    Special Tool 

    1. SUZUKI scan tool (SUZUKI-SDT) 
    Fig 1: Connecting Scan Tool To DLC
    G06526595Courtesy of SUZUKI OF AMERICA CORP.
  3. Push engine switch to change ignition mode of keyless push start system to "ON".
  4. Read DTC according to instructions displayed on SUZUKI scan tool and prints it or write it down. Refer to SUZUKI scan tool operator's manual for further details . If communication between scan tool and ESP® control module is not possible, check that power supply and ground circuits of ESP® control module. If they are OK, go to TROUBLESHOOTING FOR COMMUNICATION BUS OFF .
  5. Confirm that ignition mode of keyless push start system is in "OFF" and disconnect SUZUKI scan tool from DLC after completing check.
scientia non olet · About LEMON Manuals