CVT Model

DIAGNOSIS PROCEDURE

Step	Action	YES	NO
1	DTC check Is any DTC other than B1125 detected?	Go to troubleshooting for applicable DTC.	Go to Step 2.
2	DTC check Check DTC in TCM, see DTC TABLE . Is there any DTC(s) detected?	Go to troubleshooting for applicable DTC.	Go to Step 3.
3	Transmission range sensor signal circuit check Push engine switch to change ignition mode to "OFF". Disconnect transmission range sensor, "C01", "E01", "E04" and "L01" connectors. Check for proper terminal connection to transmission range sensor, "C01", "E01", "E04" and "L01" connectors. If connections are OK, check the following points. Resistance of "A1" circuit: less than 3 Ω Resistance between "A1" circuit and ground: infinity Resistance between "A1" circuit terminal and each terminal at transmission range sensor connector: infinity Are they in good condition?	Go to Step 4.	Repair or replace defective wire harness.
4	P position switch signal circuit check Check "A2" circuit according to Step 1 of DTC B1126 . Are they in good condition?	Go to Step 5.	Repair or replace defective wire harness.
5	Transmission range sensor check Check transmission range sensor, see TRANSMISSION RANGE SENSOR INSPECTION . Is it in good condition?	Go to Step 6.	Replace transmission range sensor, see TRANSMISSION RANGE SENSOR REMOVAL AND INSTALLATION .
6	P position switch check Check P position switch, see P POSITION SWITCH INSPECTION . Is it in good condition?	Replace keyless start control module and recheck DTC, see KEYLESS START CONTROL MODULE REMOVAL AND INSTALLATION .	Replace select lever. Refer to SELECT LEVER ASSEMBLY REMOVAL AND INSTALLATION