DTC Troubleshooting

NOTE: If immobilizer registration is not performed normally, check whether or not ECM suites with specification or CAN communication DTC is not shown. Further, check remote controller itself.

DIAGNOSIS PROCEDURE

Step	Action	YES	NO
1	Remote controller registration Perform "Immobilizer Key Registration". Confirm that ignition mode of keyless push start system is "OFF". Push engine switch to change ignition mode to "ON". Recheck DTC. Is DTC B1175 still detected?	Replace keyless start control module and recheck DTC, see KEYLESS START CONTROL MODULE REMOVAL AND INSTALLATION .	End. (Remote controller was not registered)