LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2013 >> Kizashi Base, Automatic CVT Trans >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Communication System >> Diagnostic Information and Procedures >> Troubleshooting For Communication Bus Off >> Communication Check >> SDM
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Communication Check: SDM

  1. Push engine switch to change ignition mode to "OFF".
  2. Connect "G11" connector to SDM.
  3. Push engine switch to change ignition mode to "ON".
  4. Select "Communication Bus Check" under "Bus Check" menu of SUZUKI scan tool.
  5. Confirm the CAN communication that control modules, sensors and SDM have been already connected on is in normal condition, see JUDGMENT OF COMMUNICATION BUS CHECK  .
  6. If any malfunction is found, substitute a known-good SDM and recheck DTC, see SDM REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals