Driver Air Bag (Inflator) Module Removal and Installation: Installation

Reference: DRIVER AIR BAG (INFLATOR) MODULE INSPECTION 

1. Connect driver air bag (inflator) module connector (1) to driver air bag (inflator) module (2) securely as shown in the figure.
   1. Connect connector.
   2. Lock connector with lock button (3).
      Fig 1: Connecting Driver Air Bag (Inflator) Module Connector To Driver Air Bag (Inflator) Module

      Courtesy of SUZUKI OF AMERICA CORP.
2. Install driver air bag (inflator) module (1) to steering wheel (2), taking care so that no part of wire harness is caught between them.
3. Make sure that clearance between module (1) and steering wheel (2) is uniform all the way.
4. Tighten left side bolt (3) of driver air bag (inflator) module first and then right side bolt (4).

   Tightening torque 

   Driver air bag (inflator) module mounting bolt (a): 9 N.m (0.9 kgf-m, 6.5 lbf-ft) 

5. Install steering wheel side caps (5).
   Fig 2: Identifying Steering Wheel, Driver Air Bag (Inflator) Module, Side Caps And Side Bolts

   Courtesy of SUZUKI OF AMERICA CORP.
6. Enable air bag system. Refer to ENABLING AIR BAG SYSTEM  .
7. Connect negative (-) cable at battery.