Select Cable Adjustment

WARNING: This page is about a different variant/trim than selected.

Loosen manual select cable nut.
Shift select lever to "N".
Align center line (1) on manual shift shaft (2) to "N" reference line (3) as shown in figure.

Fig 1: Identifying Manual Shift Shaft, Center Line And "N" Reference Line
Courtesy of SUZUKI OF AMERICA CORP.
Tighten manual select cable nut (1) to specified torque.
Tightening torque

Manual select cable nut (a): 13 N.m (1.3 kgf-m, 9.5 lbf-ft)

Fig 2: Identifying Manual Select Cable Nut
Courtesy of SUZUKI OF AMERICA CORP.
After select cable was adjusted, check for the following.
- Push vehicle with selector lever shifted to "P". Vehicle should not move.
- Vehicle can not be driven in "N".
- Vehicle can be driven in "D", "3", "2" and "L".
- Vehicle can be backed in "R".