A/T Relay Inspection

WARNING: This page is about a different variant/trim than selected.

Disconnect negative cable at battery.
Remove power integration relay No. 2 (1) from fuse box No. 2 (2).

Fig 1: Removing Power Integration Relay No. 2 And Fuse Box No. 2
Courtesy of SUZUKI OF AMERICA CORP.
Check that there is no continuity between terminals "E41-1" and "E38-8". If there is continuity, replace relay.
Connect battery positive (+) terminal to terminal "E38-6" of relay. Connect battery negative (-) terminal to terminal "E38-7" of relay. Check for continuity between terminal "E41-1" and "E38-8". If there is no continuity when relay is connected to the battery, replace power integration relay No. 2.

Fig 2: Checking Continuity Between Terminals "E41-1" And "E38-8"
Courtesy of SUZUKI OF AMERICA CORP.