LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2012 >> SX4 SportBack, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Tire Pressure Monitoring System) >> Repair Instructions >> Registration Procedure for Tire Pressure Sensor ID Code >> Not using SUZUKI scan tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Not using SUZUKI scan tool

WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Confirm that all doors are closed and ignition key is out of ignition key cylinder.
  2. Open driver side door.
  3. Perform the following Steps  a) to  c) within 15 seconds after ignition switch turned ON.
    1. Press driver side door switch hand within 5 seconds after ignition switch turned ON. Keep the switch pressed for 2 seconds.
    2. Release driver side door switch and then press driver side door switch for 2 seconds or more by hand.
    3. Release driver side door switch and then press driver side door switch for 2 to 5 seconds by hand.
      Fig 1: Tire Pressure Sensor ID Code Registration Procedure Timing Pattern
      G06869238Courtesy of SUZUKI OF AMERICA CORP.
  4. Using special tool, activate each tire pressure sensor within 90 seconds.

    Refer to the instruction of special tool for the method of activating tire pressure sensor.

    NOTE:
    • When tire pressure sensor is to be activated, set the special tool to the same position as shown in the illustration below. If the special tool is set to other positions, there is a possibility that tire pressure sensor cannot be activated.
    • When tire pressure sensor is activated, flashing LED and beeping sound of special tool indicate an activation of the tire pressure sensor. In case that LED does not flash and beeping sound is not heard even if special tool is normal, replace faulty tire pressure sensor.
    • When tire pressure sensor is activated, ID code of the tire pressure sensor is registered automatically in BCM.
    • If each ID code of 4 tire pressure sensors is not registered in BCM within 90 seconds, start all over from Step  1). Also, it is possible to check the number of ID codes of tire pressure sensors received by BCM by observing the flashing pattern of the low tire pressure warning light.
    • When BCM receives each ID code of 4 tire pressure sensors, BCM turns ON low tire pressure warning light in combination meter for 5 seconds.

    Special Tool 

    (A): 09945-86510 

    Fig 2: Low Tire Pressure Sensor Warning Light Timing Pattern
    G06869239Courtesy of SUZUKI OF AMERICA CORP.
  5. After registration is completed, turn ignition switch to OFF position.
scientia non olet · About LEMON Manuals