Transmission Range Sensor Removal and Installation: Removal
WARNING: This page is about a different variant/trim than selected.
- Disconnect negative cable from battery.
- Remove air cleaner assembly. See AIR CLEANER ASSEMBLY REMOVAL AND INSTALLATION
- Remove clip of select cable and disconnect select cable from manual select lever. See Select Cable Components
- Shift manual select lever (2) to "N" position.
Insert pin remover (4 mm) (1) to aligning hole on manual select lever (2) and check that the position of aligning hole on transmission range sensor (3) as shown in figure.
- Disconnect transmission range sensor connector.
- Remove manual select lever nut (1) and manual select lever (2).
- Remove transmission range sensor bolts (3) and transmission range sensor (4).